On order
-
Paiement sécurisé / livraison Colissimo
Description
Product information "kdFi V1.4 PNP VW PY (G40)"
The kdFi V1.4 is installed in a VW housing and loaded with an initial setup for G40 (PY) engines.
The MAP sensor is good up to 1,5 bar boost and can be replaced by a 3 bar sensor if needed.
Customer to do:
- Change Engine Management
- START ENGINE !
- do your own setup
This product is only street legal with special permission in most countries. Please check local laws before using on official streets.
Features:
- MAP sensor based setup (optimal for turbo conversions)
- full compatible to MSextra Software
- build your own setup
- MS2 onboard / Firmware MS2extra
- free Software / Open Source
- Fuel Table 16x16
- Ignition Table 12x12
- USB Connector
- Widebandlambdacontroller (www.breitband-lambda.de)
- supports low impedance injectors
- supports stock idle valves
- user programmable Relaisoutput
- electronical boost control
- Tacho output
- supports CAN Bus
- compatible with the Lambdas Sensor LSU 4.2
- MAP sensor based setup (optimal for turbo conversions)
- full compatible to MSextra Software
- build your own setup
- MS2 onboard / Firmware MS2extra
- free Software / Open Source
- Fuel Table 16x16
- Ignition Table 12x12
- USB Connector
- Widebandlambdacontroller (www.breitband-lambda.de)
- supports low impedance injectors
- supports stock idle valves
- user programmable Relaisoutput
- electronical boost control
- Tacho output
- supports CAN Bus
- compatible with the Lambdas Sensor LSU 4.2
Scope of delivery:
- kdFi V1.4 Plug and Play ECU
- USB Cable
- Software CD
- kdFi Manual
16 autres produits dans la même catégorie :
Référence: 61678362823
Marque: BMW
Gicleur téléscopique
(0)
Nécessite les références 61 67 4 290 867 et 61 67 4 290 868
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order