On order
-
Paiement sécurisé / livraison Colissimo
Description
Product information "kdFi V1.4 PNP BMW M40"
The kdFi V1.4 is mounted and wired in a Motronic housing and loaded with an initial setup for M40 engines.
(not for the E36 with 88-pin control unit)
Customer to do:
- Replace Throttle Position Switch with Throttle Position Sensor e.g. from M50 engine (not included in delivery)
- Change Engine Management
- START ENGINE !
The control unit can be used on the following Bosch Motronics:
0 261 200 157
0 261 200 174
0 261 200 387
0 261 200 989
If your number is not listed, please contact us, using the contact form
This product is only street legal with special permission in most countries. Please check local laws before using on official streets.
Features:
- MAP sensor based setup (can be changed to alpha-N via software)
- also suitable for turbo and compressor conversions
- full compatible to MSextra Software
- build your own setup
- MS2 onboard / Firmware MS2extra
- Fuel Table 16x16
- Ignition Table 12x12
- USB Connector
- Widebandlambdacontroller (www.breitband-lambda.de)
- prepared for single coils (seperate wires needs to be connected)
- supports stock idle valves
- user programmable relay output
- electronical boost control
- supports CAN Bus
- compatible with the Lambda Sensor LSU 4.2
Scope of delivery:
- kdFi V1.4 Plug and Play ECU
- USB Cable
- Software CD
- kdFi Manual
Détails du produit
KDFIM40
Fiche technique
- B2 - Motorisation
- M40-M42-M43-M44
- Moteur - modèle
- BMW 3 E30
- Moteur - modèle
- BMW 3 E36
16 autres produits dans la même catégorie :
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order
On order
Les clients qui ont acheté ce produit ont également acheté :
On order
On order